Lexicon MC-12 Digital Controller Lexicon MC-12 - Manual (Page 173)

When an ERROR message
appears on the last CHECK
MICROPHONES screen,
press the
and
arrow buttons to highlight
the desired microphone.
Then, press the
arrow
button to view more
details about the error.
One of the messages
shown at the left will
appear on the on-screen
display.
Appendix
Lexicon
A-10
Menu Trees (continued from page A-9)
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SETUP
SPEAKER SETUP
SET CROSSOVERS
CHECK MICROPHONES
AUTOMATIC
MANUAL
SET CROSSOVERS
BEFORE CALIBRATING
SPEAKER SETUP
SET CROSSOVERS
CHECK MICROPHONES
AUTOMATIC
MANUAL
SET CROSSOVERS
BEFORE CALIBRATING
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
SPEAKERS CHECK MICROPHONES
CHECK MICROPHONES
CHECKING FOR SILENCE
PLEASE WAIT
CHECK MICROPHONES
CHECKING MICROPHONES
PLEASE WAIT
CHECK MICROPHONES
GROUP MICROPHONES
INTO A BUNDLE IN THE
MIDDLE OF THE ROOM
PRESS V TO BEGIN
MIC CHECK
CHECK MICROPHONES
MIC 1 ERROR
MIC 2 OK
MIC 3 OK
MIC 4 0K
PRESS V TO VIEW
DETAILS
MIC 1 ERROR
(MICROPHONE)
OK
(MICROPHONE)
TOO MUCH ROOM NOISE
AUTO SPEAKER SETUP
DISTANCES & LEVELS
DISTANCES
OUTPUT LEVELS
PLACE MICROPHONES
IN PRIMARY LISTENING
POSITIONS
or
When an ERROR message appears on the last CHECK
MICROPHONES screen, pressing the
arrow button
opens the SPEAKER SETUP menu. When no ERROR
message appears on the last CHECK MICROPHONES
screen, pressing the
arrow button opens the AUTO
SPEAKER SETUP menu.
(MICROPHONE)
SIGNAL TOO LOW
(MICROPHONE)
OUT OF RANGE
(MICROPHONE)
NOT DETECTED
or
or
or