Lincoln Electric POWER MIG 11521 - Manual (Page 68)

Wire Drive
FIGURE F.9 – WIRE DRIVE LOCATION
WIRE DRIVE MOTOR REMOVAL AND REPLACEMENT PROCEDURE
(continued)
PROCEDURE
1. Remove power to the machine.
2. Lift cover to gain access to the wire drive. See
Figure F.9.
3. Using a pair of pliers, disconnect the gas hose
from the bottom of the wire drive. See Figure
F.10.
4. Using a 9/16” nut driver, remove the thick black
positive lead located just above the gas hose.
See Figure F.10.
NOTE: Disconnect lead from the wire drive motor
assembly, not the machine.
5. Using a 5/16” nutdriver, remove the three
mounting screws next to the wire drive assem-
bly. See Figure F.10.
6. Using a 5/16” nutdriver, remove the two screws
on the case front assembly. See Figure F.11.
7. Carefully maneuver the wire drive assembly out
the side of the machine to gain access to plug
J4. See Wiring Diagram.
8. Disconnect plug J4.
TROUBLESHOOTING AND REPAIR F-30 F-30
Power MIG® 215XT
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC