Lucent Technologies GW-DS300N - Manual (Page 23)

2
18
GW-DS300N
1. Right click on the icon; there are two items for users to operate
the utility.
œ Launch Config Utilties
Click it to enter the utility program of GW-DS300N
œ Use Zero Configuration as Configuration utility
Click it and the adapter will stop working immediately and
GW-DS300N will not be the default utility anymore. If you
want to use GW-DS300N as the default utility again, just click
“Use PCIConfig as Configuration utility”.
œ Switch to AP Mode
Click it to change the adapter mode of GW-DS300N into AP
mode. If you want to use the adapter function, please click
“Switch to Station Mode”.
œ Exit
Select “Exit” to close the configuration utility tool.
2. The GW-DS300N icon changes from time to time to reflect the
current wireless network connection status. The status indicates
as follows:
ĈThe signal strengh is good..
ĈThe signal strength is normal.
ĈThe signal strength is weak.
ĈGW-DS300N has not connected to any AP yet.
ĈGW-DS300N is unplugged or it is not in use.