Lucent Technologies GW-DS300N - Manual (Page 68)

4
64
GW-DS300N
4.4 Access Control
Click on the“Access Control”tab on the homepage of the AP mode and
you can start to set the MAC address filter function. Please refer to the
instructions below.
Items Descriptions
Access Policy Scroll down the list to set if you want to use access
control function. GW-DS300N has three kinds of
access policies:
“Disable”,“Allow All”, and“Reject All”. The default
setting is “Disa ble”.
Disable – Do not use access control function.
Allow All – Only the MAC addresses listed in the
Access List can connect with GW-DS300N.
Reject All – Only the MAC addresses listed in the
Access List can NOT connect with GW-DS300N.
MAC Address MAC address is a unique identification for hardware
devices on the network. It is a 12-digit hexadecimal
value. Fill in the MAC addresses of wireless adapters
you want to accept or reject to access GW-DS300N
in this table.
Access List Here displays all the accepted or rejected MAC
addresses.
Delete Choose a MAC address which you want to delete in
the Access List, and click this button to delete it.
Remove All Click this button to delete all the MAC addresses in
the Access List.