Lucent Technologies GW-DS300N - Manual (Page 24)

2
19
Chapter 2 Basic Installation & Configuration
2. Open the configuration utility of GW-DS300N, the“Site Survey”
page displays several settings. The items and the setup instructions
are listed below. After opening the utility, the system will scan all the
channels to find all the access points/stations within the accessible range
and automatically connect to one of the wireless APs which has the
highest signal strength. The green icon which shows two hands holding
together means GW-DS300N is connecting with the AP.
Items Descriptions
SSID The SSID (up to 32 printable ASCII characters)
is a unique name identified in a WLAN. The SSID
can prevent the unintentional merging of two
co-located WLANs.
You may assign an SSID for GW-DS300N, and only
the device with the same SSID can interconnect to it.
BSSID It displays the MAC Addresses of the APs which
GW-DS300N has detected.
Signal The box displays all the SSIDs (Service Set
Identifier) and signal strength of the APs nearby. To
detect the available wireless devices again please
click“Rescan.”
There are two ways to make a connection between
GW-DS300N and one of the APs on the list:
1.Double-click the wireless station on the list
directly.
2.Select the station you intend to connect and then
click“Connect.”