Lucent Technologies GW-DS300N - Manual (Page 47)

3
42
GW-DS300N
Auto–Based on the status of the network and
automatically disable/enable protection mode.
On–Always enable the protection mode.
Off–Always disable the protection mode.
Tx Rate There are several options including Auto/1/2/5.5/11/
6/9/12/18/24/36/48/54Mbps for you to select. When
“Auto”is selected, the device will choose the most
suitable transmission rate automatically. The higher
data rate you designated in the network, the shorter
distance is allowed between the adapter and the
wireless stations.
When the wireless mode is“802.11 B only”, the
maximum data rate is 11Mbps (11b) so that there are
only “Auto/1/2/5.5/11Mbps” options you can select.
Tx Burst Tx Burst enables the adapter to deliver better
throughput during a period of time but the function
only takes effect when connecting with the AP which
also supports Tx Burst.
Enable TCP The TCP Window is the amount of data which a
sender can send on a particular connection before
it gets an acknowledgment back from the receiver
that it has gotten some of it. When the Router or AP
which the adapter is connecting to has set up the TCP
Window, you can enable the parameter to meet the
data size for the Router or AP connection. The larger
TCP Window the better performance.
Fast Roaming at ~ When you want to fast roaming to the network nearby
without intercepting the wireless connection
Window Site
dBm