Lucent Technologies GW-DS300N - Manual (Page 63)

59
4
Chapter 4 Soft AP Mode
If enable this function, though the wireless clients
are connecting to the same AP, still they cannot share
information with each other. The system default is
not forwarding data between stations.
Hide SSID If the check box of“Hide SSID”is enabled, the AP
will not appear in the list of all the other wireless
adapters. It means only the wireless adapters
which has the same SSID can connect to the AP. In
this way, it can avoid the AP being connected by
unauthorized users. The default setting is disabled.
Allow BW40 MHz When using “802.11B/G/N mix” mode, you may
choose this function to allow BW40 MHz capability.
Default Click this button and the AP will show the default
value of this page. (Without Tx BURST, and Use
Short Slot)
Apply Click“Apply”to enable the settings you made on
this page.
OK Click“OK”button and the utility will save the
settings and close the page.
Not forwarding
among wireless
clients