Lucent Technologies GW-DS300N - Manual (Page 62)

4
58
GW-DS300N
œOff: Always send frame without protection.
Beacon(ms) The time between two beacons. System default is
100 ms.
TX Power Please manually choose the transmitting power for
GW-DS300N.There are“100% ă75%ă50%ă
25% and Lowest”. The system default is 100%
which means GW-DS300N has the maximum TX
Power on wireless network.
Idle time(60 - 3600)(s Idle Timeout means a period of idle time before
you go offline. Enter a maximum period of time
(seconds) to define the maximum idle time. If the idle
time is above the defined maximum idle
TX Rate There are several options including Auto/1/2/5.5/11/
6/9/12/18/24/36/48/54Mbps for you to select. When
“Auto”is selected, the device will choose the most
suitable transmission rate automatically. The higher
data rate you designated in the network, the shorter
distance is allowed between the adapter and the AP.
When the wireless mode is“802.11 B only”, the
maximum data rate is 11Mbps (11b) so that there are
only “Auto/1/2/5.5/11Mbps” options you can select.
Channel Scroll down the list to choose a channel for the AP.
The default setting is channel 1.
Security Setting Click this button and then to set up the authentication
and security of the AP. The detailed configuration is
shown in the“4.3. Security Setting”.