Phonetics 2000 - Manual (Page 48)

48
CPP Monitor 2000 User’s Manual
Note that for N.O. and N.C. input types, units of NONE will result
in the unit speaking “open” or “closed” during a status report.
Selectable units of measure: none, degrees F, degrees C, inches,
feet, gallons, liters, psi, gpm, volts, amps, hours, minutes, seconds
Default setting: none
Alarm Programming tab:
The Alarm Programming tab shows the name, high and low alarm
limits, alarm recognition time, call list, dialout enable status, and
alarm reset time for all of the inputs.
Listed below is a description of each of the programming options
found on the Alarm Programming tab of the Inputs form:
Inputs Name:
This field will allow you to type in a 16 character description for
each input.
Alarm Low Limit:
This is the value which will cause the unit to make alarm dialouts
on an input low condition.
0-5V, 4-20mA, and Temperature:
Programmable range: -99,999.9 to 99,999.9
Default setting: 0