Panasonic WR-DA7 - Manual (Page 166)

[Rx]
Switch bulk command reception or by pressing the
ENTER button.When this is OFF, the DA7 ignores any of
commands or data sent by external devices.
Button
Begin bulk data reception from another DA7 by pressing the ENTER
button. If a MIDI device other than DA7 is connected, you need to have
the device start sending data.
Button
Begin bulk data transmission to an outside device by pressing the
ENTER button.
Data being received or sent is shown every 10% during [REQUEST] or
[BULK OUT] communication. To cancel communication cursor to the
button and press the ENTER button.
[INTERVAL] Area
Set a data transmission interval to match the processing speed of the
receiving device. Cursor to the soft knob, and rotate the
JogDial to set
the internal time within 0-300 ms (by 50 ms steps).
If the device has a small capacity receive memory buffer, set a short
interval (for example, 100 ms). Intermittent transmission prevents the
receive memory buffer from overflowing. Intervals can be set at 50-ms
increments. A 0-ms interval is acceptable when two DA7s are connected
together.
Button
To stop bulk data transmission or reception cursor to the button
and press the ENTER button.
Data selection
Cursor to the button(s) to select the desired bulk data in the [BULK I/O DATA
SELECT] area, and press the ENTER button. Multiple buttons can be
selected. Selected button(s) are highlighted.
Pressing the button selects all the buttons that appear in the area.
OFF ON
C h a p t e r 1 1
D A 7 U s e r s ’ G u i d e 11 - 1 2
11
MIDI