Panasonic WR-DA7 - Manual (Page 209)

[MMC] Area
The [MMC] area provides controls for the automation system and for sending
control commands to externally connected machines (via the MIDI port on
the rear panel) that accept
MMC (MIDI Machine Control) commands.
To operate this area it is practical to use the KeyPad in the MMC mode. Set
the Keypad to MMC mode by selecting the MMC/CURSOR button before
operating.
[ ] - [ ] Buttons
Select these buttons to quickly access the desired locate points in an
automated mix. See page
14-10, Create Locate Points and Recall
Locate Points for more information.
[Play ] Button
Select this button to Play the current automated mix (once the Internal
Clock is selected and Automation and Record are enabled). The
[Play
] button also can be used to independently control any connected
device that accepts MMC commands. When the MMC/CURSOR is in
MMC mode, the up ARROW button on the Top Panel provides
the same control.
[Rewind ] Button
Select this button to Rewind the current automated mix (once the
Internal Clock is selected and Automation and Record are enabled). The
[Rewind
] button also can be used to independently control any
connected device that accepts MMC commands. When the
MMC/CURSOR is in MMC mode, the left ARROW button on
the Top Panel provides the same control.
[Fast Forward ] Button
Select this button to Fast Forward the current automated mix (once the
Internal Clock is selected and Automation and Record are enabled). The
[Fast Forward
] button also can be used to independently control
any connected device that accepts MMC commands. When the
MMC/CURSOR is in MMC mode, the right ARROW button on
the Top Panel provides the same control.
FF ▼ ▼
REW
▼ ▼
PLAY ▼
C h a p t e r 1 4
D A 7 U s e r s ’ G u i d e 14 - 9
14
Automation
MMC Area