Psion Teklogix Schnellstart- Anleitung 7525 - Manual (Page 298)

Chapter 8: Expansion Modules
Installing An SE 1223HP Scanner
268 Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
8.1.6 Installing An SE 1223HP Scanner
Warning: Anti-static devices MUST BE USED during the installation of
this scanner module. If unavailable, discharge static from your
body by touching a grounded metallic object before opening any
covers on the unit.
The SE 1223HP scanner (model # WA9000) is the internal scanner module
available with the WORKABOUT PRO. To install it:
• Remove the battery. If your unit is using AC power, disconnect it.
• Remove the stylus and then, remove the end-cap at the top of the
WORKABOUT PRO.
• Slide the SW1401 switch to the left to shut off internal battery power.
• Remove the back plate from the unit.
A scanner flex cable is already attached to the WORKABOUT PRO. You need to
connect the flex cable to the internal scanner module.
• Remove the adhesive tape which holds the flex cable in a folded position.
• Insert the flex cable into the connector on the scanner module. If necessary,
use pincers to hold the flex cable.
Figure 8.9 Attaching The Flex Cable To The Scanner Module
Scanner
Connector
Module
Flex
Cable