3 battery swap time, 4 charging the battery, 1 chargers and docking stations – Psion Teklogix Schnellstart- Anleitung 7525 User Manual

Page 55: 3 battery swap time 3.3.4 charging the battery

Advertising
background image

Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual

25

Chapter 3: Getting To Know The WORKABOUT PRO

Battery Swap Time

3.3.3 Battery Swap Time

Assuming the default power saving parameters and battery reserve level have not

been altered, battery swap time is between 10 and 15 minutes—you will not lose

data if the battery is replaced within this time frame.
Keep in mind that user data is stored in a RAM-based folder by default—data in

these RAM folders is lost if the main and backup batteries are completely drained,

or if the unit is cold reset. The safest place to store data is in the \Storage (onboard

FFS) folder or on an SD or MMC memory card.
To protect against data loss, the unit will automatically shut down with enough

reserve in the main battery to last up to 72 hours.

3.3.4 Charging The Battery

Batteries shipped from the factory are charged to approximately 40% of capacity.

They must be fully charged prior to use.
Keep in mind also that, along with the main battery, the WORKABOUT PRO is

equipped with an internal, backup battery that preserves data stored on the unit

while the main battery is swapped.
Important:

The backup battery is trickle charged from the main battery. To
maximize battery life, avoid excessive discharging and recharging
of the backup battery by keeping the main battery fully charged.
IF YOU ARE POWERING UP A NEW UNIT, a warning message
may appear on the screen indicating that the backup battery
capacity is low. To recharge the backup battery, you must fully
charge the WORKABOUT PRO with the main battery installed in
the unit. An overnight charge is recommended.

3.3.4.1

Chargers And Docking Stations

Important:

FOR DETAILED INFORMATION about chargers and docking
stations, refer to
Chapter 9: Peripheral Devices & Accessories

beginning on page 280.
For battery safety, refer to “Lithium Ion Battery Safety Precau-
tions” b
eginning on page 280.

Lithium Ion battery packs must be charged before use. These batteries can be

charged with a variety of chargers and docking stations. These include:

Desktop Docking Station (Model #WA4002-1)—operates as both a charger

and a docking station. Operating as a charger, both the battery installed in

the hand-held and a spare battery can be charged simultaneously.

Advertising