Psion Teklogix Schnellstart- Anleitung 7525 - Manual (Page 56)

Chapter 3: Getting To Know The WORKABOUT PRO
Switching The Hand-Held On And Off
26 Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
• Quad Docking Station (Model #WA4004)—can charge the battery of up to
four WORKABOUT PROs inserted in the docking station.
• Single Battery Charger (Model #WA3001)—charges a single battery.
• Quad Battery Charger (Model #WA3004)—charges up to four spare Stan-
dard or High-Capacity WORKABOUT PRO battery packs.
It can take up to 5 hours to charge a battery. The WORKABOUT PRO’s intelligent
charging system protects the battery from over-charging by terminating the charge
process when the battery is at maximum capacity.
Note: Refer to “Monitoring The Battery And Maximizing Run Time” on page 39
for additional information about the battery.
Important: To avoid damaging the battery, chargers will not begin the charge
process until the battery temperature is between 0° C to 45 °C
(32° F to 113° F).
3.4 Switching The Hand-Held On And Off
Switching On The WORKABOUT PRO
• Press and hold down the <ENTER/ON> key for at least one second.
• When the LED flashes green, release the <ENTER/ON> button.
The startup Today screen is displayed.
Note: If the WORKABOUT PRO is in suspend state, pressing <ENTER/ON>
key ‘wakes’ the unit from this state. The screen in which you were working
before the computer entered suspend state is displayed.
Switching Off The WORKABOUT PRO (Suspend)
Important: Keep in mind that turning off the WORKABOUT PRO does not
result in a complete reboot; rather, the unit enters a power-saving,
“suspend” state. When the unit is turned on from suspend state,
operation resumes within a few seconds.
To switch off the WORKABOUT PRO:
• Press the <BLUE> key, and then press the <ENTER/ON> key.