Psion Teklogix Schnellstart- Anleitung 7525 - Manual (Page 300)

Chapter 8: Expansion Modules
Enabling The SE 923HP Scanner
270 Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
The SE 923HP scanner (model # WA9002) is the internal scanner module available
with the WORKABOUT PRO. To install it:
• Remove the battery. If your unit is using AC power, disconnect it.
• Remove the stylus and then, remove the end-cap at the top of the
WORKABOUT PRO.
• Slide the SW1401 switch to the left to shut off internal battery power.
• Remove the back plate from the unit.
A scanner flex cable is already attached to the WORKABOUT PRO. You need to
connect the flex cable to the internal scanner module.
• Remove the adhesive tape that holds the flex cable in a folded position.
• Insert the flex cable into the connector on the scanner module (refer to
Figure 8.9 on page 268). If necessary, use pincers to hold the flex cable.
• Fit the scanner module over the back of the WORKABOUT PRO—it
replaces the back plate of the unit.
• Fasten the module in place with the screws provided. Tighten the screws to
a torque of 3 lbs-in (3kgf-cm), or until finger tight.
• Slide the SW1401 power switch to the right to turn power back on, and
replace the end-cap and battery. Tighten the end-cap screws to a torque of 3
lbs-in (3kgf-cm), or until finger tight
8.1.7.1 Enabling The SE 923HP Scanner
• Simultaneously, press and hold down the <BLUE> <ENTER> and left
<SCAN> keys for a minimum of 6 seconds. A
Command>
prompt is dis-
played on the WORKABOUT PRO screen.
• Type s to display the
Scanner>
prompt. A list of supported scanners is dis-
played.
• Type 3 and press <ENTER> to activate scanner type SE 923HP.
• At the
Command>
prompt, type 1 (one) to reboot the unit to Windows Mobile
2003 SE.