Panasonic WJ-NT104 - Manual (Page 18)

18
● Access Procedures
Follow these procedures to access the WJ-NT104 from a PC running Windows95 or Windows98 via a PPP type connection.
1. Preparations
q Check that the following software is installed in the PC.
• TCP/IP protocol
The TCP/IP protocol comes as an accessory with Windows95/98. Access the Control Panel
→
Network dialog box.
If TCP/IP
→
Dial-Up Adapter is not listed, you need to install the TCP/IP protocol.
For details refer to the Windows95/98 help file.
• Dial-Up Networking
Dial-Up Networking comes as an accessory with Windows95/98. If the Dial-Up Networking icon is not in My
Computer , it is not installed. To find out how to install it, refer to the Windows95/98 help file.
w Check the destination.
Check the phone number, phone system (type of line), communication speed, etc. of the client that will access the WJ-
NT104.
e Connect a modem or TA to the PC and set it up.
The following description is based on the assumption that the device to which the modem or TA will be connected has
already been set up. For the modem or TA connection, refer to the instruction manual for the modem or TA.
2. Connection Setup
To access the WJ-NT104, set up the connection using Dial-Up Networking. It needs to be set up only once.
If the
Dial-Up Networking icon is not in My Computer , it is not installed. You can use the following procedure to install it.
(1) Click the Start button, point to Settings , and then click Control Panel .
(2) Double-click Add/Remove Programs .
(3) Click the Windows Setup tab, click Communications , and then click the [Details] button.
(4) Click the Dial-Up Networking check box, and then click the [OK] button.
Click OK again, and follow the instructions on your screen.
q Double-click My Computer , and then double-click Dial-Up Networking .