Panasonic WJ-NT104 - Manual (Page 45)

45
!6
!0 !1 !2 !3 !4
!5
!7
i PORT No.
Same as the alarm terminal numbers on the rear panel
o ALARM FUNCTION
Set the alarm function to ON or OFF.
!0 CAMERA CH
Specify a camera channel to be selected when an
alarm is activated.
!1 CAMERA PRESET
Specify a preset position for the camera when an alarm
is activated.
This is valid only when a camera with preset function is
connected.
!2 DELAY TIME (per 100 msec)
Set the time from activation of an alarm to the start of
recording.
!3 ALARM CONTACT
Select between normally closed (NC) and normally
open (NO) alarm contact.
open: Accepts an NC alarm signal
close: Accepts an NO alarm signal
!4 SET button
Clicking this button saves the settings in the WJ-NT104.
!5 ALARM NOTICE (SMTP E-MAIL)
To use the e-mail notice function, select YES.
!6 SERVER ADDRESS
Specify the address of the mail server to which mail is
sent directly from the WJ-NT104.
!7 SENDER NAME
Set the name of a mail sender (up to 8, alphanumeric
characters lower case).
!8 Destination E-Mail address
Specify the destination mail addresses of alarm notice
recipients. Up to 16 addresses can be set.
!9 Delete destination E-Mail addresses
Displays the list of e-mail addresses to receive alarm
notices. Clicking the DELETE button will delete an
address from the list.
@0 ALARM NOTICE (Panasonic Protocol)
If Panasonic's special alarm receiving software* is
installed, mark YES to use the alarm notice function.
* This software will be available in the near future as an
option.
@1 DESTINATION PORT
Specify 1818.
@2 RETRY NUMBER OF TIMES
Enter the number of retries in the event that an alarm
notice is undeliverable.
@3 Destination IP address
Specify the IP addresses of PCs to which an alarm
notice is to be sent. Up to 16 IP addresses can be set.
@4 Delete destination IP addresses
Displays the list of IP addresses to receive alarm
notices. Clicking the DELETE button will delete an
address from the list.
i o
!8
!9
@0
@1
@2
@3
@4