M-det setting, Archive pointer reset, Archive – Pelco DX3000 User Manual
Page 27: Data, Archive pointer reset archive
26
Pelco Manual C681M-D (2/02)
6.
Do one of the following:
•
Turn the JOG dial to go to another item in this menu.
•
Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
•
Press the SET UP button to exit the programming mode.
M-DET SETTING
Refer to
Motion Detection for instructions.
ARCHIVE POINTER RESET
The recorder places the Archive Pointer where the archive stops. For example, 100 hours of
data recorded on the unit’s hard disk is to be transferred to a medium with only 80 hours of
available recording space. When the backup process is completed, the Archive Pointer will
memorize the hard disk’s 80-hour mark. When the next backup process is initiated, backup
will begin at this point.
If you want to reset the Archive Pointer, follow the steps below.
Skip steps 1 and 2 if they have already been done.
1.
Press the SET UP button to display the Menu Setting menu.
2.
Move the cursor next to SERVICE, and then turn the SHUTTLE ring to the right.
The Service menu appears.
3.
Turn the JOG dial until the cursor is next to ARCHIVE POINT RESET, and then turn
the SHUTTLE ring to the right. The option starts flashing.
4.
Turn the JOG dial to select ON.
5.
The message “TURN THE SHUTTLE RING >> to EXECUTE.” appears on the screen.
Turn the SHUTTLE ring to the right to reset the archive pointer. The pointer resets and
the option returns to OFF.
6.
Do one of the following:
•
Turn the JOG dial to go to another item in this menu.
•
Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
•
Press the SET UP button to exit the programming mode.
ARCHIVE
DATA
When backing up records onto backup media, it is possible to back up all data on the hard
disk drive or to select and back up only the alarm portions of the records.
Skip steps 1 and 2 if they have already been done.
1.
Press the SET UP button to display the Menu Setting menu.
2.
Move the cursor to INITIAL SET UP, and then turn the SHUTTLE ring to the right.
The Initial Set Up menu appears.
3.
Turn the JOG dial move the cursor to ARCHIVE DATA, and then turn the SHUTTLE
ring to the right.
NOTE:
This menu item
does not appear unless an
archiving device is con-
nected to the recorder.