Pelco DX3000 - Manual (Page 35)

34 Pelco Manual C681M-D (2/02)
HARD DISK DRIVE (HDD) REPEAT PLAYBACK
When the end of the hard disk drive (HDD) is reached during playback, you can set the re-
corder either to stop playback or to continue playback from the beginning of the disk.
Skip steps 1 and 2 if they have already been done.
1. Press the SET UP button to display the Menu Setting menu.
2. Turn the JOG dial until the cursor is next to INITIAL SET UP, and then turn the
SHUTTLE ring to the right. The Initial Set Up menu appears.
3. Turn the JOG dial until the cursor is next to HDD PB REPEAT, and then turn the
SHUTTLE ring to the right. The option starts flashing.
NOTE: If the PRE A-REC field in the A-Rec/M-Det Setting menu has been set to
SHORT, MEDIUM, or LONG, the option does not flash because it cannot be
changed.
4. Turn the JOG dial to select REPEAT or STOP, and then turn the SHUTTLE ring to the
right. The option stops flashing.
REPEAT: At the end of the hard disk, the recorder continues playback from the begin-
ning of the disk.
STOP: The recorder stops playback at the end of the hard disk.
5. Do one of the following:
• Turn the JOG dial to go to another item in this menu.
• Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
• Press the SET UP button to exit the programming mode.
IM-CHECK MODE
This function checks to determine if the recorded video has been altered. This function can
check the recorded video on the internal hard drive as well as video from external devices.
The authentication software analysis each frame of the video stream to verify that the
watermarking is present and that the original video has not been changed. If an image is
modified, a small black square appears in the modified area of the image. If the image is
an alarm, a small black square also appears on the screen next to the alarm number.
The message “WARNING: MODIFIED IMAGE” appears on the screen along with the num-
bers of the affected cameras.
Skip steps 1 and 2 if they have already been done.
1. Press the SET UP button to display the Menu Setting menu.
2. Move the cursor next to SERVICE, and then turn the SHUTTLE ring to the right.
The Service menu appears.
3. Turn the JOG dial until the cursor is next to IM-CHECK MODE, and then turn the
SHUTTLE ring to the right. The option starts flashing.
NOTE: If the PRE A-REC field in the A-Rec/M-Det Setting menu has been set to
SHORT, MIDDLE, or LONG, the option does not flash because it cannot be
changed.
4. Turn the JOG dial to select ON or OFF, and then turn the SHUTTLE ring to the right.
The option stops flashing.