Buzzer – Pelco DX3000 User Manual
Page 30
Pelco Manual C681M-D (2/02)
29
5.
Do one of the following:
•
Turn the JOG dial to go to another item in this menu.
•
Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
•
Press the SET UP button to exit the programming mode.
BUZZER
You can set the buzzer to sound under different conditions, depending on the option se-
lected.
Skip steps 1 and 2 if they have already been done.
1.
Press the SET UP button to display the Menu Setting menu.
2.
Turn the JOG dial to move the cursor to REAR TERMINAL, and then turn the
SHUTTLE ring to the right. The Rear Terminal menu appears.
3.
Turn the JOG dial until the cursor is next to BUZZER, and then turn the SHUTTLE ring
to the right. The option flashes.
4.
Turn the JOG dial to select the option, and then turn the SHUTTLE ring to the right.
The option stops flashing.
Turning the JOG dial switches the buzzer options as follows:
KEY, WRNG, REMAIN, OFF
KEY:
The buzzer sounds when any button is pressed or the JOG dial or SHUTTLE
ring is turned.
WRNG:
The buzzer sounds when a warning occurs. Refer to the
Warnings section.
REMAIN:
The buzzer sounds when the remaining storage capacity of hard drive
reaches the preset amount selected in CAPACITY REMAIN. Press the WARNING RE-
SET button to stop the buzzer.
OFF:
The buzzer does not sound.
5.
Do one of the following:
•
Turn the JOG dial to go to another item in this menu.
•
Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
•
Press the SET UP button to exit the programming mode.