Initialize menus, Mode out, Initialize menus mode out – Pelco DX3000 User Manual
Page 36
Pelco Manual C681M-D (2/02)
35
5.
Do one of the following:
•
Turn the JOG dial to go to another item in this menu.
•
Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to
another menu.
•
Press the SET UP button to exit the programming mode.
INITIALIZE MENUS
Initializing the menus returns most settings to their default values.
Skip steps 1 and 2 if they have already been done.
1.
Press the SET UP button to display the Menu Setting menu.
2.
Turn the JOG dial to move the cursor to SERVICE, and then turn the SHUTTLE ring to
the right. The Service menu appears.
3.
Turn the JOG dial until the cursor is next to MENU INITIALIZE, and then turn the
SHUTTLE ring to the right. The option starts flashing.
NOTE:
If the PRE A-REC field in the A-Rec/M-Det Setting menu has been set to
SHORT, MEDIUM, or LONG, the option does not flash because it cannot be
changed.
4.
Turn the JOG dial to select ON or OFF.
5.
If you selected ON, “PUSH WARNING RESET KEY THEN ALL MENU WILL BE INI-
TIALIZED.” appears on the screen. Press the WARNING RESET button. The 9-camera
screen (DX3009 models) or 16-camera screen (DX3016 models) appears on the
monitor and menus are reset to their default values, except for the time and date dis-
play, timer program settings, and camera titles. The Selected Pattern setting is set to
P1 in the Timer Program. The Menu Initialize option returns to OFF and stops flashing.
If you selected OFF, turn the SHUTTLE ring to the right. The option stops flashing.
6.
Do one of the following:
•
Turn the JOG dial to go to another item in this menu.
•
Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
•
Press the SET UP button to exit the programming mode.
MODE OUT
With this setting, a signal can be output to indicate the status of the recorder.
Skip steps 1 and 2 if they have already been done.
1.
Press the SET UP button to display the Menu Setting menu.
2.
Turn the JOG dial to move the cursor to REAR TERMINAL, and then turn the
SHUTTLE ring to the right. The Rear Terminal menu appears.
3.
Check that the cursor is next to MODE OUT, and then turn the SHUTTLE ring to the
right. The option starts flashing.