Pelco DX3000 - Manual (Page 28)

Pelco Manual C681M-D (2/02) 27
4. Turn the JOG dial to select the option, and then turn the SHUTTLE ring to the right.
Turning the JOG dial switches the archive data options as follows:
ALL: This backs up all the data recorded on the main hard disk after the archive
pointer. Alternatively, all data will be backed up.
ALARM: Of all the data blocks recorded on the main hard disk (1 MB units), this will
back up only the data blocks that contain the alarm record. Some data on either side
of the alarm record may be included when backing up a small alarm record.
5. Do one of the following:
• Turn the JOG dial to go to another item in this menu.
• Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
• Press the SET UP button to exit the programming mode.
OVERWRITE
This setting determines whether the recorder will overwrite data on the archive medium
when making a new archive. When set to ON, all data on the archive medium will be over-
written.
Skip steps 1 and 2 if they have already been done.
1. Press the SET UP button to display the Menu Setting menu.
2. Turn the JOG dial until the cursor is next to INITIAL SET UP, and then turn SHUTTLE
ring to the right. The Initial Set Up menu appears.
3. Move the cursor to ARCHIVE OVERWRITE, and then turn the SHUTTLE ring to the
right until the option flashes.
4. Turn JOG dial to select ON or OFF, and then turn the SHUTTLE ring to the right.
The option stops flashing.
The Archive Pointer is recorded when backup is either temporarily stopped or finished.
Using the Archive Pointer, the recorder will begin the next backup at the end point of
the previous backup.
5. Do one of the following:
• Turn the JOG dial to go to another item in this menu.
• Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
• Press the SET UP button to exit the programming mode.
NOTE: This menu item
does not appear unless an
archiving device is con-
nected to the recorder.