Psion Teklogix 9160 G2 - Manual (Page 179)

Psion Teklogix 9160 G2 Wireless Gateway User Manual 157
Chapter 15: Configuring VLANs
Navigating To Virtual Wireless Network Settings
The following sections describe how to configure multiple wireless networks on
Virtual LANs (VLANs).
15.1 Navigating To Virtual Wireless Network Settings
To set up multiple networks on VLANs, navigate to the Manage > Virtual Wireless
Networks tab, and update the fields as described below.
15.2 Configuring VLANs
Note: To configure additional networks on VLANs, you must first enable Virtual
Wireless Networks on the Ethernet Settings page. See “Enabling / Dis-
abling Virtual Wireless Networks On The AP” on page 136.
Important: If you configure VLANs, you may lose connectivity to the access
point. First, be sure to verify that the switch and DHCP server you
are using can support VLANs per the IEEE 802.1Q standard.
After configuring VLANs, physically reconnect the Ethernet
cable on the switch to the tagged packet (VLAN) port. Then,
re-connect via the Administration Web pages to the new IP
address. (If necessary, check with the infrastructure support
administrator regarding the VLAN and DHCP configurations.)