Psion Teklogix 9160 G2 - Manual (Page 226)

Chapter 20: Wireless Distribution System
Configuring WDS Settings
204 Psion Teklogix 9160 G2 Wireless Gateway User Manual
The following notes summarize some critical guidelines regarding WDS configura-
tion. Please read all the notes before proceeding with WDS configuration.
Notes: • When using WDS, be sure to configure WDS settings on both access
points participating in the WDS link.
• You can have only one WDS link between any pair of access points. That
is, a remote MAC address may appear only once on the WDS page for a
particular access point.
• Both access points participating in a WDS link must be on the same
Radio channel and using the same IEEE 802.11 mode. (See Chapter 16:
“Configuring 802.11 Radio Settings” for information on configuring the
Radio mode and channel.)
• When 802.11h is operational, setting up WDS links can be difficult. See
“802.11h Regulatory Domain Control” on page 142.
To configure WDS on this access point, describe each AP intended to receive hand-
offs and send information to this AP. Each destination AP needs the following
description, as shown in Table 20.4.
Field Description
Radio The 9160 G2 Wireless Gateway is available as a one-radio or two-radio access point.
One-Radio AP:
On the one-radio version of the 9160 G2 Wireless Gateway, this field is not included on the WDS tab.
Two-Radio AP:
For each WDS link on a two-radio AP, select Radio One or Radio Two. The rest of the settings for the
link apply to the radio selected in this field. The read-only “Local Address” will change depending on
which Radio you select here.
Table 20.4 Destination Access Point Settings