Psion Teklogix 9160 G2 - Manual (Page 312)

Appendix C: Security Settings On Wireless Clients And RADIUS Server Setup
WPA/WPA2 Enterprise (RADIUS) Client Using EAP/PEAP
C-20 Psion Teklogix 9160 G2 Wireless Gateway User Manual
C.7.1 WPA/WPA2 Enterprise (RADIUS) Client Using EAP/PEAP
The Built-In Authentication Server on the 9160 G2 Wireless Gateway uses Pro-
tected Extensible Authentication Protocol (EAP) known as “EAP/PEAP”.
• If you are using the Built-in Authentication server with “WPA/WPA2
Enterprise (RADIUS)” security mode on the 9160 G2 Wireless Gateway,
then you will need to set up wireless clients to use PEAP.
• Additionally, you may have an external RADIUS server that uses
EAP/PEAP. If so, you will need to:
(1) Add the 9160 G2 Wireless Gateway to the list of RADIUS server cli-
ents.
AND
(2) Configure your “WPA/WPA2 Enterprise (RADIUS)” wireless clients to
use PEAP.
Note: The following example assumes you are using the Built-in Authentication
server that comes with the 9160 G2 Wireless Gateway. If you are setting
up EAP/PEAP on a client of an AP that is using an external RADIUS
server, the client configuration process will differ somewhat from this
example especially with regard to certificate validation.