Psion Teklogix 9160 G2 - Manual (Page 196)

Chapter 17: MAC Address Filtering
Using MAC Filtering
174 Psion Teklogix 9160 G2 Wireless Gateway User Manual
17.2 Using MAC Filtering
This page allows you to control access to the 9160 G2 Wireless Gateway based on
Media Access Control (MAC) addresses. Based on how you set the filter, you can
allow only client stations with a listed MAC address or prevent access to the
stations listed.
For the Guest interface, MAC Filtering settings apply to both BSSes.
On a two-radio AP, MAC Filtering settings apply to both radios.
17.3 Updating Settings
To update MAC settings:
1. Navigate to the MAC Filtering tab page.
2. Configure the MAC settings as required.
3. Click the Update button to apply the changes.
Field Description
Filter To set the MAC Address Filter, click one of the following radio buttons:
• Allow only stations in the list
• Block all stations in list
Stations List To add a MAC Address to Stations List, enter its 48-bit MAC address into the lower text boxes, then
click Add.
The MAC Address is added to the Stations List.
To remove a MAC Address from the Stations List, select its 48-bit MAC address, then click Remove.
The stations in the list will either be allowed or prevented from accessing the AP based on how you set
the Filter.
Table 17.1 MAC Filtering Settings