Psion Teklogix 9160 G2 - Manual (Page 70)

Chapter 5: Configuring Basic Settings
Review / Describe The Access Point
48 Psion Teklogix 9160 G2 Wireless Gateway User Manual
5.2 Review / Describe The Access Point
Field Description
IP Address Shows IP address assigned to this access point. This field is not editable because the IP address is
already assigned (either via DHCP, or statically through the Ethernet (wired) settings as described
in “Configuring Guest Interface Ethernet (Wired) Settings” on page 138).
MAC Address Shows the MAC address of the access point.
A MAC address is a permanent, unique hardware address for any device that represents an inter-
face to the network. The MAC address is assigned by the manufacturer. You cannot change the
MAC address. It is provided here for informational purposes as a unique identifier for an interface.
The address shown here is the MAC address for the bridge ( br0 ). This is the address by which the
AP is known externally to other networks.
To see MAC addresses for Guest and Internal interfaces on the AP, see the
Status, Interfaces tab.
Firmware Version Version information about the firmware currently installed on the access point.
As new versions of the 9160 G2 Wireless Gateway firmware become available, you can upgrade
the firmware on your access points to take advantages of new features and enhancements.
For instructions on how to upgrade the firmware, see “Upgrading The Firmware” on page 255.
Table 5.1 Basic Settings Screen Options