Perle Systems IOLAN SCS - Manual (Page 127)

127
Serial Port Profiles
TCP Port The TCP port that the IOLAN will use to listen for incoming connections.
Default: 10000 plus the serial port number, so serial port 5 would have a
default of 10005
Allow Multiple
Hosts to Connect When this option is enabled, multiple hosts can connect to the serial device that
is connected to this serial port.
Default: Disabled
Connect To When enabled, the IOLAN initiates communication to the Workstation/Server.
Default: Disabled
Host Name The name (resolvable via DNS) or IP address of the configured host the
IOLAN will connect to.
TCP Port The TCP Port that the IOLAN will use to communicate to the client.
Default: 0
Connect to
Multiple Hosts When enabled, allows a serial device connected to this serial port to
communicate to multiple hosts.
Default: Disabled
Define Additional
Hosts Button Click this button to define the hosts that this serial port will connect to. This
button is also used to define the Primary/Backup host functionality.
Initiate Connection
Automatically If the serial port hardware parameters have been setup to monitor DSR or
DCD, the host session will be started once the signals are detected. If no
hardware signals are being monitored, the IOLAN will initiate the session
immediately after being powered up.
Default: Enabled
Initiate Connection
When any data is
received Initiates a connection to the specified host when any data is received on the
serial port.
Default: Disabled
Initiate Connection
When <hex value>
is received Initiates a connection to the specified host only when the specified character is
received on the serial port.
Default: Disabled
Permit
Connections in
Both Directions When this option is enabled, the connection can be initiated by either the
IOLAN or a host.
Default: Disabled