Perle Systems IOLAN SCS - Manual (Page 301)

301
Management
TFTP Tab Field Descriptions
You must have a TFTP server running on any host that you are uploading or downloading files
to/from.
Configure the following parameters:
Console Port Tab Field Descriptions
This tab is found on rack mount models and is used to configure the Admin/Console port.
Configure the following parameters:
Note: TFTP file transfers send via UDP packets. When the packet delivery is interrupted for any
reason and a timeout occurs, that packet is resent if the retry count allows it. Therefore, if a
very large file is being transferred and is interrupted, the entire file is not resent, just the part
of the file that was not received.
Retry The number of times the IOLAN will retry to transmit a TPFT packet to/from a
host when no response is received. A value of 0 (zero) means that the IOLAN
will not attempt a retry should TFTP fail.
Range: 0-5
Default: 5
Timeout The time, in seconds, that the IOLAN will wait for a successful transmit or
receipt of TFTP packets before retrying a TFTP transfer.
Range: 3-10
Default: 3 seconds
Baud Rate
x
Specifies the baud rate of the line connected to the dedicated console port.
Data Options: 9600, 19200, 38400, 57600, 115200
Default: 9600
Flow Control For IOLAN models that have a dedicated console port, defines how the data
flow is handled.
Data Options:
z Soft—Data flow control is handled by the software.
z Hard—Data flow control is handled by the hardware.
z None—There is no data flow control.
Default: None