Perle Systems IOLAN SCS - Manual (Page 136)

Serial Port Profiles
136 IOLAN SDS/SCS/STS User’s Guide, Version 3.6
Connect to Remote
System When the serial port is started, the IOLAN will initiate a connection to the
specified host using the specified protocol. With this option, user
authentication will not be performed by the IOLAN.
Default: Disabled
Protocol Specify the protocol that will be used to connect to the specified host.
Data Options: Telnet, SSH, Rlogin
Default: Telnet
Settings Button Click this button to define the settings for the protocol that will be used to
connect the user to the specified host.
Host Name The name (resolvable via DNS) or IP address of the configured host the
IOLAN will connect to.
TCP Port The TCP Port that the IOLAN will use to connect to the host.
Default: Telnet-23, SSH-22, Rlogin-513
Automatically If the serial port hardware parameters have been setup to monitor DSR or
DCD, the host session will be started once the signals are detected. If no
hardware signals are being monitored, the IOLAN will initiate the session
immediately after being powered up.
Default: Enabled
When any data is
received Initiates a connection to the specified host when any data is received on the
serial port.
Default: Disabled
When <hex value>
is received Initiates a connection to the specified host only when the specified character is
received on the serial port.
Default: Disabled