Planet Technology SGSD-1022 - Manual (Page 466)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
466
show dot1x
This command shows general port authentication related settings on the switch or a specific interface.
Syntax
show dot1x [statistics] [interface interface]
statistics - Displays dot1x status for each port.
interface ethernet unit/port
-unit - Stack unit. (Range: 1)
-port - Port number. (Range: 1-26)
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
• Global 802.1X Parameters – Shows whether or not 802.1X port authentication is globally enabled on the Managed
Switch.
• 802.1X Port Summary – Displays the port access control parameters for each interface, including the following items:
-Status – Administrative state for port access control.
-Operation Mode – Dot1x port control operation mode.
-Mode – Dot1x port control mode.
-Authorized – Authorization status (yes or n/a - not authorized).
• 802.1X Port Details – Displays the port access control parameters for each interface, including the following items:
-reauth-enabled - Periodic re-authentication.
-reauth-period - Time after which a connected client must be re-authenticated
-quiet-period - Time a port waits after Max Request Count is exceeded before
attempting to acquire a new client
-tx-period - Time a port waits during authentication session before
re-transmitting EAP packet.
-supplicant-timeout - Supplicant timeout.
-server-timeout - Server timeout.
-reauth-max - Maximum number of reauthentication attempts.
-max-req - Maximum number of times a port will retransmit an EAP
request/identity packet to the client before it times out the
authentication session
-Status - Authorization status (authorized or not). -Operation Mode –
Shows if single or multiple hosts (clients) can connect to an
802.1X-authorized port.
-Max Count - The maximum number of hosts allowed to access this port