Planet Technology SGSD-1022 - Manual (Page 668)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
668
Command Usage
Use the ping command to see if another site on the network can be reached.
• The following are some results of the ping command: -Normal response - The normal response occurs in one to ten
seconds, depending on network traffic. -Destination does not respond - If the host does not respond, a “timeout” appears
in ten seconds. -Destination unreachable - The gateway for this destination indicates that the destination is unreachable.
- Network or host unreachable - The gateway found no corresponding entry in the route table.
Press <Esc> to stop pinging.
IP Interface Commands
Example
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5 seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 10 ms, Maximum = 20 ms, Average = 10 ms
Console#