Rate-limit, 19 address table commands – Planet Technology SGSD-1022 User Manual
Page 537
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
537
by the hardware to verify conformity. Non-conforming traffic is dropped.
Command
Function
Mode
rate-limit
Configures the maximum input or output rate for a port
IC
Table 5-60 Rate Limit Commands
rate-limit
This command define the rate limit for a specific interface. Use the no form to restore the default status of disabled.
Syntax
rate-limit {input | output} scale {1k | 10k | 100k | 1m | 10m} level level no rate-limit {input | output}
input – Input rate limit
• output – Output rate limit
scale – The traffic rate limit scale. (Options: 1K, 10K, 100K, 1M, or 10M bytes per second)
level – The traffic rate limit level. (Range: 1-127)
Default Setting
Status: Disabled
Scale: 10M bytes per second
Level: 1
Command Mode
Interface Configuration (Ethernet)
Command Usage
The scale and level are multiplied by one another to set the rate limit. For
Example
, to limit port traffic to 500K bytes per
second, select the scale as 100K and set the level to 5.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input scale 100k level 5
Console(config-if)#
5.19 Address Table Commands
These commands are used to configure the address table for filtering specified addresses, displaying current entries, clearing
the table, or setting the aging time.