Planet Technology SGSD-1022 - Manual (Page 83)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
83
Default: 5 seconds
This parameter only applies to SNMP applications which use data stored in the
LLDP MIB for network monitoring or management. Information about changes in
LLDP neighbors that occur between SNMP notifications is not transmitted. Only
state changes that exist at the time of a notification are included in the
transmission. An SNMP agent should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
• MED Fast Start Count
Configures the amount of LLDP MED Fast Start LLDPDUs to transmit during the
activation process of the LLDP-MED Fast Start mechanisim.
Range: 1-10 packets;
Default: 4 packets
The MED Fast Start Count parameter is part of the timer which ensures that the
LLDP-MED Fast Start mechanism is active for the port. LLDP-MED Fast Start is
critical to the timely startup of LLDP, and therefore integral to the rapid availability
of Emergency Call Service.
4.2.12.2 LLDP Port Configuration
Use the LLDP Port Configuration to specify the message attributes for individual interfaces, including whether messages are
transmitted, received, or both transmitted and received, whether SNMP notifications are sent, and the type of information
advertised.
Figure 4-2-28 LLDP Port Configuration page screenshot