Planet Technology SGSD-1022 - Manual (Page 600)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
600
management.
Information about changes in LLDP neighbors that occur between SNMP notifications is not transmitted. Only state
changes that exist at the time of a notification are included in the transmission. An SNMP agent should therefore
periodically check the value of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
Example
Console(config)#lldp notification-interval 30
Console(config)#
lldp refresh-interval
This command configures the periodic transmit interval for LLDP advertisements. Use the no form to restore the Default
Setting .
Syntax
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP advertisements are sent. (Range: 5 - 32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Command Usage
This attribute must comply with the following rule:
(refresh-interval * holdtime-multiplier) ≤ 65536
Example
Console(config)#lldp refresh-interval 60
Console(config)#
lldp reinit-delay
This command configures the delay before attempting to re-initialize after LLDP ports are disabled or the link goes down.
Use the no form to restore the Default Setting .
Syntax
lldp reinit-delay seconds
no lldp reinit-delay