Panasonic HYBRID IP-PBX KX-TDA200 - Manual (Page 190)

1.20 E1 Line Service Features
190 Feature Guide
[Explanation]
Conditions
• If an E1 line is used as a trunk, the channel type depends on the contract with the
telephone company.
• If " MFC-R2 " is selected as the Dial Mode, the PBX always sends a dial tone, instead of the
telephone company, when making a trunk call using E1 line.
Number in
the table
Feature Description
(1) TIE Line Service Refer to the TIE Line Service feature. ( 1.27.1 TIE Line
Service)
(2) Direct Inward
Dialling (DID) Refer to the DID feature. ( 1.1.1.3 Direct Inward Dialling
(DID)/Direct Dialling In (DDI))
(3) Direct In Line
(DIL) Refer to the DIL feature. ( 1.1.1.2 Direct In Line (DIL))
(4) Automatic
Number
Identification
(ANI) Outgoing ANI:
Sends the caller’s number to the E1 line. The sending
method is the same as ISDN CLIP service. (
1.19.1.2
Calling/Connected Line Identification Presentation (CLIP/
COLP))
Incoming ANI:
Receives the caller’s number from the E1 line.
When the ANI number is received, it can be treated the
same as a Caller ID number. (
1.16.1 Caller ID)
(5) Call Charge
Information The call charge meter pulses can be received during a
conversation. (
1.24.2 Charge Meter)