Panasonic HYBRID IP-PBX KX-TDA200 - Manual (Page 28)

1.1 Incoming Call Features
28 Feature Guide
Each of them can have different intercept destinations for each time mode (day/lunch/break/
night) (
2.2.4 Time Service).
[Available Intercept Destination]
Conditions
• Intercept Routing—Busy/DND on/off
Each Intercept Routing—Busy and Intercept Routing—DND can be enabled or disabled
through system programming.
If disabled, one of the following is activated depending on the trunk card type which a call
arrives through:
a) LCOT or T1 (LCOT/GCOT) Card: The incoming trunk call will ring at the original
destination while the caller hears a ringback tone.
b) Other Trunk Cards: Busy tone will be sent to the caller.
• If the intercept destination cannot receive the call:
a) Intercept Routing—No answer: Intercept timer will restart at the original destination,
until the call is answered.
b) Intercept Routing—Busy/DND: The call will be sent back to the original destination
when the call arrives through the LCOT or T1 (LCOT/GCOT) card. When the call
arrives through other trunk cards the caller will hear busy tone.
Feature Guide References
1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)
*: This is applied only when a trunk call arrives on a DISA line but the line is busy at that time.
Once the call reaches the destination extension by using the DISA feature, the Intercept
Routing feature of the extension works.
Intercept Destination Availability
Wired Extension (PT/SLT/ISDN Extension/T1-OPX)
PS
Incoming Call Distribution Group
PS Ring Group
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analogue/ISDN Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. +
Phone no.
Other PBX Extension (TIE with no PBX Code)
Other PBX Extension (TIE with PBX Code)