Printronix T3306 - Manual (Page 34)

2–14 Setting Up the Printer
Figure 2–12. Media Loading
4. Push the roller bracket forward to its closed position.
5. Route the free end of the media to the internal rewind hub and attach as
described in the Optional Media Rewind Hub section above.
NOTE: It is possible to use the present sensor only (without installing the
peel and present mechanism) with the tear bar to provide
on-demand printing in the tear-off mode. To operate in this mode,
media should be routed as shown in
Figure 2–7 and the Media
Handling menu selection should be set to Self Strip (see
Figure 3–7 ).