Printronix T3306 - Manual (Page 55)

3–11 Configuring the Printer
5. Press and hold
or
to scroll through the values.
6. Press to select a value. An asterisk (*) displays next to the selected
value.
7. If there are more values you want to change, use the
keys to access the value and the key to select it. At any time, you
may press the key to return to the options one level higher.
8. At any time, you may also press the key to save your changes, then
the
ON LINE/
PAUSE
to exit the configuration menu and place the
printer on line. Once you have finished selecting all your options, save
your configuration.
CAUTION
If you do not save your configuration, all your new values will be lost
when you turn off the printer.
Saving Your New Configuration
You can save up to eight different configurations to meet eight unique print job
requirements. For example:
Config. 0: Factory Default (This cannot be altered.)
Config. 1: Selects RS–232 Serial Interface
Selects Page Width of 4 inches
Selects Page Length of 24 inches
Selects image Horizontal Shift of 0.20 inches, etc.
Config. 2: Selects Parallel Interface
Selects Page Width of 2.2 inches
Selects Page Length of 25.0 mm
Selects image Vertical Shift of 0.10 inches, etc.
The configurations are saved and stored in nonvolatile memory for later use.
These configurations, including the factory default configuration, will not be
erased from memory when the printer power is turned off.
If you do not save your configuration (to the nonvolatile memory) before you turn
off the printer, that current configuration will be lost.
NOTE: If the Protect Save CFG option is enabled, the new configuration will
not be saved unless the existing configuration has been deleted.