NEC uPD75P3116 - Manual (Page 57)

µ
PD75P3116
57 Data Sheet U11369EJ3V0DS
PROM Write Tools
Hardware PG-1500 This is a PROM writer that can program a single-chip microcontroller with PROM in stand-alone
mode or under the control of a host machine when connected with the supplied accessory board
and optional programmer adapter.
It can also program typical PROMs in capacities ranging from 256 Kb to 4 Mb.
PA-75P3116GC This is a PROM programmer adapter for the µ PD75P3116GC-AB8.
It can be used when connected to the PG-1500.
PA-75P3116GK This is a PROM programmer adapter for the µ PD75P3116GK-8A8.
It can be used when connected to the PG-1500.
PA-75P3116GC-8BS This is a PROM programmer adapter for the µ PD75P3116GC-8BS.
It can be used when connected to the PG-1500.
Software PG-1500 controller Connects the PG-1500 to the host machine via serial and parallel interfaces and controls the
PG-1500 on the host machine.
Host machine Part number
OS Supply medium
(Product name)
PC-9800 Series MS-DOS 3.5" 2HD µ S5A13PG1500
Ver.3.30 to
Ver.6.2
Note
IBM PC/AT Refer to OS for 3.5" 2HD µ S7B13PG1500
or compatible IBM PCs
Note Ver. 5.00 and later include a task swapping function, but this function cannot be used in this software.
Remark Operation of the PG-1500 controller is guaranteed only when using the host machine and OS described above.