Nlynx OMNITERM WBT 2.1.0E User Manual
Page 65
Terminal Properties
If you use a Magtek Magnetic Strip Reader with keyboard, you may set the
configuration of that Reader from this screen. Refer to MAGTEK MSR manual
for the complete set of configuration commands.
To setup specific tracks to be read, input the following commands:
Track 1 data only...01381
Track 2 data only...01384
Track 3 data only...01390
Track 1 and 2 data...01385
Track 1 and 3 data...01391
Track 2 and 3 data...01394
Track 1, 2 and 3 data...01395 (default)
Input the command, then click OK to close the driver screen and execute the
command. Open up the driver screen again, place the cursor after the
command, and swipe the credit card to make sure the correct track data is
coming up on the screen.
Volume Control
Use this control to set the volume on the terminal speakers. Click the Up or
Down arrows to position pointer to desired volume level from Soft to Loud.
62