Nlynx ETU400 - Manual (Page 113)

ETU400 User Guide 011603 9-9
The PCTOPC Command
To transfer a single file from one micro to multiple micros, specify the
name of the file, the device name of the micro from which the file is
being transferred, and the name of the device or devices to which the
file is being transferred.
QFNAME1 The name of the micro file to be transferred. If
you are transferring a file to multiple micros,
the file name, including the path name, must be
identical on each micro. For additional
information, see About Microcomputer Files in
Chapter 3.
MICLST1 The device name of the source micro. The default,
*REQUESTER, transfers the file from the micro on
which the PCTOPC command is currently being run.
(To transfer a file from a different micro, enter
the device name of the micro. You must be
authorized to use the device you specify in this
parameter, or the transfer will fail.)
NOTE: This parameter must be changed from
*REQUESTER to the name of the source micro when
you run this command in batch mode.
MICLST2 The device name of the micro to which the file is
being transferred. You can transfer the file to
up to ten micros. (To transfer the file to more
than one micro, enter the device name of each
micro. You must be authorized to use each device
you specify in this parameter, or the transfer
will fail.)
Enter a plus sign ( ) here and press ENTER to
display multiple MICLST2 prompts.
Each device you transfer to must be powered on,
have emulation loaded, and have the AS/400 sign-
on screen displayed.