Compile procedures – Nlynx ETU400 User Manual
Page 272
ETU400 User Guide 011603
G-2
About This Appendix
Some users of ETU/400 may be more familiar with the operating system of
System/36 than with that of the AS/400. For this reason, ETU/400 supports
a set of commands in System/36 mode, in addition to the native AS/400
commands.
The commands that are supported in both the native mode and System/36
mode are listed in this chapter. Any native command can be used by a
System/36-mode OCL procedure. The syntax of the native command when used
in OCL is the same as entering the command from the System/36-mode
command line (all uppercase letters).
However, most native commands do not return status codes in the LDA so
the abnormal completion of a native command cannot be detected by the OCL
procedure. For this reason, System/36-specific commands
are available in ETU/400.
This appendix describes how to access the System/36-mode menu and how to
execute the commands. Finally, this appendix describes each command
available in Sytem/36 mode, listed in alphabetical order.