Nlynx ETU400 - Manual (Page 31)

ETU400 User Guide 011603 2-6
If you have a version of ETU prior to 5.01 and have modified or created
translation tables, you must modify the tables further for ETU 5.01. The
information below assumes you are familiar with the terminology and steps
required to modify the translation tables, as defined in the ETU 400 User
Guide.
The host-to-micro source members for the PC (ETOA1) or the Mac (ETOA1M),
or any user-defined table that was created using these members, must be
modified as described below.
For ETOA1
The FROM HEX value 09 must have a TO HEX value of 09.
The FROM HEX value 0A must have a TO HEX value of 0A.
The FROM HEX value 0D must have a TO HEX value of 0D.
For ETOA1M
The FROM HEX value 09 must have a TO HEX value of 09.
The FROM HEX value 0A must have a TO HEX value of 0D.
The *EOR record must be changed from 0D0A to 0D.
The *EOF record must be changed from 1A to blank since the Mac uses no
end-of-file character.
After you change the source, be sure to run the EDITTABLE command.
Registering Your Host System
ETU 400 is licensed to be installed on a single host system, and may be
run on only that system. After you install the ETU software on your host,
you are granted a 30-day evaluation period.
Older versions of ETU (CISC) require specific host registration. If you
have purchased an older version of ETU, you must obtain a host
registration number from NLynx Technologies during this 30-day period to
allow unlimited use of the software on your host system.
NOTE: Once you receive your ETU host registration number from NLynx
Technologies, you may not return ETU for a refund.
Newer versions of ETU do not require registration. We will require a
serial number prior to providing Technical Support.
Using ETU During the Evaluation Period
You do not need a host registration number while you are using ETU in the
evaluation period. However, until you register ETU with NLynx
Technologies, you will see a reminder prompt whenever you issue any ETU
transfer command. Do not press Enter at the prompt.