Nlynx ETU400 - Manual (Page 153)

ETU400 User Guide 011603 10-23
LPI The number of lines per inch to allocate to the new print job
being added to the AS/400 print queue. The default is 6.
CPI The number of characters per inch to allocate to the new
print job being added to the AS/400 print queue. The default
is 10.
WIDTH The width of the forms being printed. Valid entries are 1
through 198. The default value is 132.
OVERFLOW The overflow line on the new print job being added to the
print queue (OUTQ). The default is 63.
FORMTYPE The forms type label to associate with the new print job
being added to the print queue (OUTQ). The default is *STD.
COPIES The number of copies of the new print job to print. The
default is 1.
HOLD Specifies whether the print file will be held on the print
queue at the completion of the translation/transfer.
*NO The print file will start immediately upon termination
of this command (the default).
*YES The print file must be started by the operator.
TRANSFILE The qualified file name of the translation table file to be
used. The default is TRANSLATE.
Library The name of the library containing the TRANSFILE. *LIBL is
the default.
TRANSMBR The TRANSFILE member name. The default name is ATOE3, an
ASCII-to-EBCDIC table supplied with ETU.