Nlynx ETU400 - Manual (Page 24)

ETU400 User Guide 011603 1-8
Features of Version 5.6
Version 5.6 is the latest release.
This release supports changes in Operating System V5R1. The issue was a
problem transferring AS/400 spool files to the PC. When you select the
Output queue, you could not see any of the files that were in that queue.
It is downward compatible with older versions of OS/400.
Notes to Mac Users
Most of the information in this manual is relevant to all microcomputer
workstation users. However, some information is specific only to Mac
users. Such information is expressed in the following format:
Mac Users: This is how Mac-specific information is presented.
Compatibility with Non-ES32 Emulation Products
ETU is currently only supported with NLynx Techologies ES32 emulation.
There once was a DOS Compatibility disk with a program called IBMTRAN
that enabled any emulation to work. This software only works with other
DOS software using serial COM ports. IBMTRAN was never ported to the
Windows environment. IBMTRAN doesn't work with Windows 95 or any later
Windows Operating Systems. It is not supported because the Windows
Registry makes this too difficult. IBMTRAN is no longer supported.
If you would like to try it, without support, you can get it from our
website at http://www.nlynx.com/html/tb-etu400.htm click on the link:
ETU Compatibility Program for REAL DOS Only. (See ETU Compatibility
Diskette: For non-ES32 Emulation Products in Chapter 2.)
Native Mode and System/36 Mode
ETU 400 supports two sets of commands, one in the AS/400 native mode and
the other in System/36 mode on the AS/400. Chapters 3 through 10 are for
the native mode command set. Appendix G addresses the commands and
operation for System/36 mode. System/36 mode interface does not support
the new features and commands listed above.