Nlynx ETU400 - Manual (Page 157)

ETU400 User Guide 011603 10-27
PWRDELETEB Command
Parameter description Parameter name Parameter values
Qualified file name QFNAME micro file name
Process done on which
micro?
MICLIST *REQUESTER
device name
Notify Operator? NOTIFY *YES or *NO
Display status message? DSPSTSMSG *YES or *NO
Use PWRDELETEB to delete a PC file on a specified micro from either a PC
in emulation mode or from a dumb terminal. Issue the PWRDELETEB command
from the command line and press F4 to prompt. You can also run this
command in batch mode.
The PWRDELETEB parameters are described below:
QFNAME The name of the micro file to be deleted.
MICLST The device name of the micro that contains the file to be
deleted.
*REQUESTER Deletes the file from the micro from which the
command is initiated.
device name Deletes the file from the micro with this device
name.
NOTIFY Specifies whether you will be notified if the file to be
deleted is not found. Sending a message to your message
queue does this.
*YES You are notified if the file is not found (the
default).
*NO You are not notified if the file is not found.
DSPSTSMSG Displays program status messages during the execution of the
command.
*YES Status messages are displayed (the default).
*NO Status messages are not displayed.