RGB Spectrum Quadra User's Guide - Manual (Page 17)

I N S T A L L A T I O N A N D S E T U P
Optional Items
350-7951 Quadra User’s Guide 9
.
. .
.
.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
O P T I O N A L I T E M S
RGB Spectrum can optionally provide additional equipment that may be useful
in installing and operating your Quadra system. The items listed below may be
purchased separately from RGB Spectrum.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
R A C K M OU N T IN G
The Quadra chassis is designed to be mounted in a standard 19" rack. Use the
following steps to rack mount the chassis:
1. Ensure that the Quadra chassis is positioned in the rack such that the
side air intake and exhaust vents are not blocked.
2. Using four rack screws (not supplied), rack mount the unit from the
front rack ears. Install the lower of the two mounting holes first. Rack
threads may be metric or otherwise, depending upon the rack type.
3. For additional stability at the rear of the chassis, Quadra is provided
with a rear rack bracket and extension arm. Attach the rear brackets to
the rack adapter at the rear of your chassis.
4. Slide an extension arm through the slot on the rack adapter and attach
the arm to the chassis.
5. Attach the arm to the rear bracket by means of the fasteners located in
the arms.
Table 2-2. Optional Items
Item Part Number Description
VGA Cable 520-0298-1 15-pin HD Male to 15-pin HD Male,
6 ft. Use to connect your analog
output/inputs to sources with a
female VGA connector.
VGA-to-BNC
Adapter 520-0251-1 15-pin HD Male to a 5 BNC cable
bundle Male, 6 ft. 10 inches. Use to
connect the analog output/inputs to
sources with BNC connectors.
Important Do not use the Quadra as a shelf to support other pieces of
equipment. If you do, the rack ears and mounting screws
may be damaged.