RGB Spectrum Quadra User's Guide - Manual (Page 19)

I N S T A L L A T I O N A N D S E T U P
Rear Panel
350-7951 Quadra User’s Guide 11
.
. .
.
.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
R E A R P A N E L
The figure below shows a view of the Quadra rear panel.
Figure 2-2. Quadra Rear Panel View
Descriptions of each section and connector are provided below:
1) AC Power Connector
One AC Power Connector (IEC 320 three pin) is provided for the
system’s universal power supply, which operates from any power
source with a line voltage in the range of 100 - 260 VAC.
2) Input Channel 1
Up to four connectors are provided for Input Channel 1 , as
illustrated and described below. This input supports composite,
RGB/component, S-Video and (optionally) DVI signals.
Figure 2-3. Input Channel Connectors
RS-232
10/100 BaseT Output - 1
Holes Holes Holes
DVI-2 DVI-3 DVI-4
Composite-2 RGB-2 S-Video-2 Composite-3 RGB-3 S-Video-3 Composite-4 RGB-4 S-Video-4
Holes
Composite-1 RGB-1 S-Video-1
DVI-1
Output - 2
Output - 3 Output - 4
6 2 3 4 5 7
8 9
10
11
1
1) AC Power Connector 5) Input Channel 4 9) Graphic Output 4
2) Input Channel 1 6) Graphic Output 1 10) RS-232 Serial Port
3) Input Channel 2 7) Graphic Output 2 11) Ethernet Port
4) Input Channel 3 8) Graphic Output 3
Note Click on a connector below to learn more about the
connector’s specifications.
Holes
Composite-1 RGB-1 S-Video-1
DVI-1