RGB Spectrum Quadra User's Guide - Manual (Page 40)

O P E R A T I O N S
Selecting an Input Source
350-7951 Quadra User’s Guide 32
.
. .
.
.
TP ALL GRID Enter
5. To turn off the test pattern on a single output, type:
TP <output #> OFF Enter
6. To turn off the test pattern on all outputs, type:
TP ALL OFF Enter
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S E L E C T I N G A N I N P U T S O U R C E
This section provides instructions for using the “ INputSouRCe ” command.
This command enables you to switch between input sources for each of
Quadra’s four input channel. Each input supports up to four sources:
composite, RGB/component, S-Video and (optionally) DVI.
Use the following steps to select input sources:
1. Ensure that a variety of input sources are connected to Quadra’s input
channels. A sample connection is shown below for a single channel:
Figure 3-5. Full array of input connections
2. Request help text for the command. Type:
H INSRC Enter
This action displays the command’s parameters and variables.
Figure 3-6. Help Text — Input Source Command
Note All test patterns are full screen, and override any WSR and
WDR image and output manipulations. When the test
pattern is turned off, the previous source is restored exactly.